OIL-ITF
Tips on Replacing Broken Garage Door Springs

Tips on Replacing Broken Garage Door Springs

When you have broken garage door springs that need to be replaced you can either hire a professional garage door technician to deal with them or you can do it on your own. These springs are long, heavy, which are used to support the garage door in opening and closing operations of the garage door. If you have a malfunctioning garage door with broken torsion springs which need to be taken care of following mentioned are the important steps that should be followed to get the fixing job done. Visit here http://www.progaragedooratlantaga.com to learn more procedures that will help you to ensure that the project can be finished easily. 

The most important procedure that you need to understand is to make sure that you have turned off the electricity of the garage door so you don’t get electrocuted while fixing a garage door. It is good to confirm that you have disconnected the power cord of the opener along with disconnecting it from your garage door. This safety precaution is for newer models of garage doors that are designed for automated operations. In the older models of garage door, you just need to turn off the circuit breaker or remove the fuse to turn off the power supply.

Inspect the broken garage door spring and the new one thoroughly to confirm that they are both the same. It is good to check both of them to confirm that they are the same type, size, and dimension. While picking a spring avoid grabbing them by other springs. Avoid touching the winding cones and brackets on new springs. You need to mark the torsion shaft ends using a marker or any other writing instruments.  It is necessary to make sure that your garage door will be balanced when you completed the broken garage door spring replacement job.

Wind the good spring off and unfasten the screws and bolts mounting the torsion cones and springs brackets together. Once you have finished this step in the project of broken garage door spring project, it is time to change the springs along with their required hardware. After completing this task, you need to wind up the new torsion springs. Once you have finished this step, you need to test the alignment of the garage door to see if it is balanced. In order to minimize the friction during garage door operations, you will need to do lubrication.

Once you have checked the balance of the garage door and make sure that all the hardware is tightened, it is time to reconnect the garage door opener. Although it is always advised that don’t play with the garage door but you need to open and close it few times to confirm that it is working properly. Handling garage door spring project may be convenient but you need to make sure that you are attempting it carefully because it can be an extremely dangerous job if not done correctly. It is suggested that hire a professional garage door technician deal with broken garage door spring to save your life.

 

Back to Top